Ethernet 10Base-T

This chapter shows the assembly, mounting, wiring, and power-up sequence of the hardware and wiring that may be used in an Ethernet 10BASE-T LAN. It is not intended to explain Ethernet and its many possible configurations.

Before installing any Ethernet component, pay particular attention to the individual warnings about accessibility and protection of each piece of hardware.

Ethernet Board Requirements

Ethernet 10BASE-T is available only for the 7052 Rel. 5.4, and the 7054 Rel. 1.2 and 2.1 Workstations. These workstations require an Ethernet adapter. The current adapters approved for use are:

•

7401/7454: Ethernet on the processor board (Intel Controller)

•

7452/7453: Ethernet on the processor board (AMD Controller)

•

7452 (Release 1.0): SMC EtherEZ Card

•

SMC EtherCard Plus Elite10T (a PC AT bus board) (7054 only)

•

NCR Ethernet Daughter Card

•

NCR 7054 Feature/Kit F152/K152

•

NCR 7052 Feature/Kit F706//K706